Drawing a sprig of Clover

There’s nothing complicated about this design. All you need to do is watch your proportions to keep things balanced, and that’s easy as pie.

Here’s the steps to make a nice bit of clover:

Illustration of step 1
Lightly draw a loosely defined plus. None of the arms should really be straight, but try to get them all around the same length. It’ll also help to make the arms on the side droop down.
Illustration of step 2 Now that you have a guide, loop around the top three arms to form three teardrop shapes. The points of the teardrops should overlap in the center of the plus.
Illustration of step 3 Using a few curves, turn the bottom arm into the stem.
Illustration of step 4 Clean things up a little and your clover is finished.
Back to the top of the page  

Check Also

Snake Drawing

Snake Drawing Step by Step

Snake Drawing in 3 ways will be described in this article! Snakes are a fairly …